Hydraulic Mast-Climbing System Bridges and Accessories- Premier Scaffold Solutions Columbus Ohio Bridges and Accessories

State-of-the-art robotics

Industry standard systems and processes

Complete, in-house manufacturing facilities

ProSeries Hydraulic Mast Climbing System

Bridges and Accessories

Bridges

Accessories

4 FT. BRIDGE
Dimensions	7' x 4'
Weight	975 lbs w/standard accessories
Guard Rails	One 4' Standard guard rail
Pro Bars	Eight on one end only (5 top) (3 Bottom)
Pro Bar Pins & Clips	16 - located on both sides of the bridge
Outriggers	One 6' (Top) and one 8' (Bottom)

6 FT. BRIDGE
Dimensions	7' x 6'
Weight	1,175 lbs w/standard accessories
Guard Rails	One 6' Adjustable guard rail
Pro Bars	Eight on one end only (5 top) (3 Bottom)
Pro Bar Pins & Clips	8 - located on both sides of the bridge
Outriggers	One 6' (Top) and one 8' (Bottom)
Attachments	One removable Truss and two bearing bridge chains

8 FT. BRIDGE
Dimensions	7' x 8'
Weight	1,350 lbs w/standard accessories
Guard Rails	Two 4' Standard guard rail
Pro Bars	Eight on one end only (5 top) (3 Bottom)
Pro Bar Pins & Clips	16 - located on both sides of the bridge
Outriggers	Two 6' (Top) and two 8' (Bottom)

Bridge Applications

Bearing Mode
Bearing bridges are preassembled and positioned between two ProSeries 24 ft. power units. Any combination of 4' or 8' bridges, with a 6' bearing bridge at each end, can be used for a bearing bridge. The maximum bearing bridge length is 60'.

Installation Instructions

Load Chart

Cantilever Mode
Cantilever bridges are directly connected to the ProSeries 24 ft. power unit using the Pro Bar System. Any combination of 4', 6', or 8' bridges can be used for a cantilever setup. The maximum cantilever length is 20 feet on each side of the ProSeries 24 ft. power unit.

Installation Instructions

Load Chart

Extension Mode
Extension bridges are created by alternatively placing 4' bridges to the end, front or back of the ProSeries 24 ft. power unit.

Installation Instructions

Load Chart

Connecting the Bridges

The Pro Bar System consists of a Pro Bar, Pro Bar Pin & Lynch Pin Clip and is used to connect most of Premier's components and accessories. Pro Bars are stored only in one end of any of the ProSeries bridges, (5 top) and (3 bottom), and are held in place with the Pro Bar Pins and Lynch Pin Clips.

The Pro Bar System allows components to be connected in a pre-loaded state without sag due to a 3/8" offset between the Pro Bar's 3 holes.

NOTE: Only two holes are used at any given time. The CENTER hole is ALWAYS used.

There is a difference of 3/8" between the long and short distance.
The distance from the center hole to the hole nearest the FLAT cut end is 8-1/8"
The distance from the center hole to the hole nearest the ANGLE cut end is 8-1/2"

CAUTION:

NEVER place hands or arms between bridges when connecting pieces.
ALWAYS secure the bridges at the top two outside Pro Bar connections
NEVER load any set up until the assembly is completed and balanced at both ends.
ALWAYS distribute the weight when loading the assembled set up.

Mast-Climber Features

Site Menu

Premier Scaffold Training
Premier Scaffold Distributors
Premier Scaffold Applications
Premier Scaffold Accessories
Premier Scaffold Specifications
Premier Scaffold Videos
Scaffold Documentation

Home
Contact Us
News

Contact Information

For more information, please contact
Premier Scaffold Solutions
(866) 542-1944

Premier Scaffold Solutions
6677 Broughton Ave.
Columbus, OH 43213