Standard 4' Guard Rail

• The standard 4' guard rail is the most commonly used and fits most positions on the unit, bridges and extensions.
  
  
• Insert mounts into the pockets located on the platform floor.
  
  
• For installation, lock rods must be pointing outward (unlocked position).
  
  
• Raise and pivot the lock rods inward (locked position).

Adjustable 4' To 7' Guard Rail

• The 4' to 7' guard rail fits at the ends of the unit or a 6' bridge.
  
  
• Stretch to the desired width. Insert mounts into the pockets located on the platform floor.
  
  
• For installation, lock rods must be pointing outward (unlocked position).
  
  
• Raise and pivot the lock rods inward (locked position).

Mason Guard Rail

• Use the Mason Guard Rail to block ends of the setup when working on planks.
  
  
• Install the Mason Guard Rail over all working planks at each end of the setup. Planks should exceed the collar.
  
  
• Secure in place with at least two (2) nails.

Door Guard Rail &
Sliding Door Guard Rail

• The sliding door guard rail and door guard rail eliminates the need to remove guard rails for material loading by providing an opening of 5' to 10' wide.
  
  
• The sliding door handle is located 7' from the opening, positioning the operator at a safe distance during material loading.
  
  
• The rubber flap located in the corner of the door guard rail eases installation of a bearing bridge.

Outrigger/Guard Rail Adaptor

The outrigger guard rail adaptor is used when the mason walk board area is exposed to large openings in the building face or exceeds the end of the wall.

Note: When several guard rails are required, install them in a staggered fashion.